Ipv6 manual tunnel

QUICK TIP: The DUID or the DHCP for IPv6 Unique Identifier section displays the IPv6 DHCP value that the router automatically generates. NOTE: The 6rd Tunnel allows your router to send IPv6 IP addresses over IPv4 networks. You may select Disabled, Automatic Configuration, or Manual Configuration in the 6rd Tunnel drop-down menu.  · This ends one method of configuring a 6rd tunnel. To test IPv6 connectivity, browse to, or ping, an IPv6 enabled website (example, www.doorway.ru) either by name or its IPv6 address. Before accessing by name, make sure the DNS server is capable of serving IPv6 addresses. If not, use the public or DNS server addresses. IPv6 traffic entering the tunnel endpoints is encapsulated with an IPv4 header based on the 6in4 configuration, and then routed through the IPv4 network using Switch A as the first hop. Static IPv6 routes are used to route into the tunnel interfaces.

A tunnel is a logical interface that acts as a logical connection between two endpoints. It is similar to a loopback interface in that there is no corresponding physical interface, but it is different in that there is more than one router involved. An IPv6 manual tunnel is a type of tunnel that has hard-coded source and. IPv6 over IPv4 tunneling provides a mechanism for utilizing the existing IPv4 routing infrastructure to carry IPv6 traffic between IPv6 networks. There are a number of IPv6 tunneling mechanisms. Currently only tunneling IPv6 traffic over an IPv4 network through 6in4 manually configured tunnel endpoints is supported. An IPv6 manual tunnel is a type of tunnel that has hard-coded source and destination addresses, with an IPv6 address on the tunnel itself. a. Use the interface tunnel number command to create a manual tunnel. For simplicity, use tunnel number 0 on both routers. Configure the tunnel mode for a manual tunnel with the tunnel mode ipv6ip command.

Manual; Generic routing encapsulation (GRE); IPv4-compatible; 6to4; Intrasite Automatic Tunnel Addressing Protocol (ISATAP). Figure. The video walks you through configuration of manual and GRE point-to-point tunnel on Cisco router to transport IPv6 traffic over IPv4 network. Aug ip-tunnel(8) — Linux manual page The default value for IPv6 tunnels is: tos T dsfield T tclass T set the type of service (IPv4) or.